Need some help with router config

[axlman]

Hi all,

Here at work, I have to routers hooked up for my machines that I build and connect to the internet. On one router, which is a Linksys, I use a static IP and then I have 3 machines connected to it and one line going to the other router which is a Netgear RP 614. The netgear is using DHCP to pull an IP addy from the Linksys. I have no problems with Internet connections, but If I connect a system to a line that is connected to the Netgear Router, I cannot see the systems that are on the local Workgroup. But if I connect the system to a line that is connected to the Linksys, I can see the Workgroup just fine.

So, what I need to know is: How can I get the systems that are connected to the Netgear Router to see the other machines on the Local Workgroup through the Linksys Router.

Thanks for any help

[Krell]

Axlman . . think about it . . . you have two seperate LANs thru two routers . . using NAT. Routers do not route private addresses . . such as a 192.

Easiest thing to do is replace the Netgear with a hub or switch.


.