pjfclee
April 9th, 2004, 08:56 AM
I want to open the ports on my belkin router so i can use emule properly and get high speeds.
I have 1mb broadband so it should be going faster then it is and my id is low so i think the router is to blame.
I have tried changing it but i cannot seem to get it right.
Hopefully this is all the information:
In virtual servers menu in the router page the colums (from left to right) are these:
Lan address 192.168.2.xxx
Protocol type
Lan port
Public port
Enable
I have read that these need changing to open the emule ports, i just dunno how!
my ip addrress is 192.168.x.x then after the last number there is no other numbers.
You may guess but i aint all that good with computers so any help needs to be dumb down a bit cheers!!!
I have 1mb broadband so it should be going faster then it is and my id is low so i think the router is to blame.
I have tried changing it but i cannot seem to get it right.
Hopefully this is all the information:
In virtual servers menu in the router page the colums (from left to right) are these:
Lan address 192.168.2.xxx
Protocol type
Lan port
Public port
Enable
I have read that these need changing to open the emule ports, i just dunno how!
my ip addrress is 192.168.x.x then after the last number there is no other numbers.
You may guess but i aint all that good with computers so any help needs to be dumb down a bit cheers!!!